Operation and Analysis of Modified Quasi ZSI in DCM and CCM
Keywords:
CCM, DCM, Quasi Z-source inverter
Abstract
This paper presents a new functional powered boost adjusted inverter, with improved voltage gain by incorporating an anti-parallel switch, with an implemented capacitor that allows two operating modes. These modes include continuous mode of conduction, and discontinuous operating mode. In the proposed Quasi Z-Source Inverter (QZSI), the voltage gain is significantly increased by adding auxiliary switch, without the use of passive components. The two operating modes are distinguished by varying switched capacitor QZSI inductances and load conditions. The improvement potential of the proposed CC-QZSI can be expanded further (n-stages) by connecting diodes and capacitors in n (n: number of stages). The limiting conditions for CCM / DCM were derived. Detailed analysis of the voltage control power, current inductance ripples, stresses, and converter losses on switching devices for CCM and DCM has been carried out. Both operation modes were simulated, and experimentally verified and validated.
References
[1] F. Blaabjerg, Z. Chen, and S. B. Kjaer, “Power electronics as efficient interface in dispersed power generation systems,” IEEE Trans. Power Electron., vol. 19, no. 5, pp. 1184–1194, Sep. 2004.
[2] Y. Xue, L. Chang, S. B. Kjaer, J. Bordonau, and T. Shimizu, “Topologies of single-phase inverters for small distributed power generators: An overview,” IEEE Trans. Power Electron., vol. 19, no. 5,pp. 1305–1314, Sep. 2004.
[3] N. Mohan, W. P. Robbin, and T. M. Undeland, Power Electronics:Converters, Applications, and Design, 2nd ed. Hoboken, NJ, USA:Wiley, 1995.
[4] G. F. Reed et al., “Applications of voltage source inverter (VSI) based technology for FACTS and custom power installations,” in Proc. Int. Conf. Power Syst. Technol. (PowerCon), vol. 1. Perth, WA, Australia, Dec. 2000, pp. 381–386.
[5] K. Temma, F. Ishiguro, N. Toki, I. Iyoda, and J. J. Paserba, “Clarification and measurements of high frequency harmonic resonance by a voltage sourced converter,” IEEE Trans. Power Del., vol. 20, no. 1, pp. 450–457,Jan. 2005.
[6] Y. Liu, H. Abu-Rub, B. Ge, F. Blaabjerg, O. Ellabban, and P. C.Loh, Impedance Source Power Electronic Converters, vol. 1. Hoboken,NJ, USA: Wiley, 2016.
[7] A. K. Rathore, A. K. S. Bhat, and R. Oruganti, “Analysis, design and experimental results of wide range ZVS active-clamped L-L type current-fed DC/DC converter for fuel cells to utility interface,” IEEETrans. Ind. Electron., vol. 59, no. 1, pp. 473–485, Jan. 2012.
[8] P. Xuewei and A. K. Rathore, “Novel bidirectional snubberless naturally commutated soft-switching current-fed full-bridge isolated DC/DC converter for fuel cell vehicles,” IEEE Trans. Ind. Electron., vol. 61, no. 5, pp. 2307–2315, May 2014.
[9] U. R. Prasanna and A. K. Rathore, “Analysis, design, and experimental results of a novel soft-switching snubberless current-fed half-bridge front-end converter-based PV inverter,” IEEE Trans. Power Electron., vol. 28, no. 7, pp. 3219–3230, Jul. 2013.
[10] A. D. Kiadehi, K. El Khamlichi Drissi, and C. Pasquier, “Angular modulation of dual-inverter fed open-end motor for electrical vehicle applications,” IEEE Trans. Power Electron., vol. 31, no. 4,pp. 2980–2990, Apr. 2016.
[11] D. Sun et al., “Modeling, impedance design, and efficiency analysis of quasi-Z source module in cascaded multilevel photovoltaic power system,” IEEE Trans. Ind. Electron., vol. 61, no. 11, pp. 6108–6117, Nov. 2014.
[12] H. Abu-Rub, A. Iqbal, S. M. Ahmed, F. Z. Peng, Y. Li, and G. Baoming, “Quasi-Z-source inverter-based photovoltaic generation system with maximum power tracking control using ANFIS,” IEEE Trans. Power Electron., vol. 4, no. 1, pp. 11–20, Jan. 2013.
[13] O. Ellabban, H. Abu-Rub, and S. Bayhan, “Z-source matrix converter:An overview,” IEEE Trans. Power Electron., vol. 31, no. 11,pp. 7436–7450, Nov. 2016.
[14] F. Z. Peng et al., “Z-source inverter for motor drives,” IEEE Trans.Power Electron., vol. 20, no. 4, pp. 857–863, Jul. 2005.
[15] X. Li, C. Xia, Y. Cao, W. Chen, and T. Shi, “Commutation torque ripple reduction strategy of Z-source inverter fed brushless DC motor,” IEEE Trans. Power Electron., vol. 31, no. 11, pp. 7677–7690,Nov. 2016.
[16] D. Sri Vidhya and T. Venkatesan, “Quasi-Z-source indirect matrix converter fed induction motor drive for flow control of dye in paper mill,”IEEE Trans. Power Electron., vol. 33, no. 2, pp. 1476–1486, Feb. 2018.
[17] F. Z. Peng, “Z-source inverter,” IEEE Trans. Ind. Appl., vol. 39, no. 2,pp. 504–510, Mar./Apr. 2003.
[18] A. Ravindranath, S. K. Mishra, and A. Joshi, “Analysis and PWM control of switched boost inverter,” IEEE Trans. Ind. Electron., vol. 60,no. 12, pp. 5593–5602, Dec. 2013.
[19] J. Anderson and F. Z. Peng, “Four quasi-Z-source inverters,” in Proc.PESC, Rhodes, Greece, Jun. 2008, pp. 2743–2749.
[20] S. S. Nag and S. Mishra, “Current-fed switched inverter,” IEEE Trans.Ind. Electron., vol. 61, no. 9, pp. 4680–4690, Sep. 2014.
[2] Y. Xue, L. Chang, S. B. Kjaer, J. Bordonau, and T. Shimizu, “Topologies of single-phase inverters for small distributed power generators: An overview,” IEEE Trans. Power Electron., vol. 19, no. 5,pp. 1305–1314, Sep. 2004.
[3] N. Mohan, W. P. Robbin, and T. M. Undeland, Power Electronics:Converters, Applications, and Design, 2nd ed. Hoboken, NJ, USA:Wiley, 1995.
[4] G. F. Reed et al., “Applications of voltage source inverter (VSI) based technology for FACTS and custom power installations,” in Proc. Int. Conf. Power Syst. Technol. (PowerCon), vol. 1. Perth, WA, Australia, Dec. 2000, pp. 381–386.
[5] K. Temma, F. Ishiguro, N. Toki, I. Iyoda, and J. J. Paserba, “Clarification and measurements of high frequency harmonic resonance by a voltage sourced converter,” IEEE Trans. Power Del., vol. 20, no. 1, pp. 450–457,Jan. 2005.
[6] Y. Liu, H. Abu-Rub, B. Ge, F. Blaabjerg, O. Ellabban, and P. C.Loh, Impedance Source Power Electronic Converters, vol. 1. Hoboken,NJ, USA: Wiley, 2016.
[7] A. K. Rathore, A. K. S. Bhat, and R. Oruganti, “Analysis, design and experimental results of wide range ZVS active-clamped L-L type current-fed DC/DC converter for fuel cells to utility interface,” IEEETrans. Ind. Electron., vol. 59, no. 1, pp. 473–485, Jan. 2012.
[8] P. Xuewei and A. K. Rathore, “Novel bidirectional snubberless naturally commutated soft-switching current-fed full-bridge isolated DC/DC converter for fuel cell vehicles,” IEEE Trans. Ind. Electron., vol. 61, no. 5, pp. 2307–2315, May 2014.
[9] U. R. Prasanna and A. K. Rathore, “Analysis, design, and experimental results of a novel soft-switching snubberless current-fed half-bridge front-end converter-based PV inverter,” IEEE Trans. Power Electron., vol. 28, no. 7, pp. 3219–3230, Jul. 2013.
[10] A. D. Kiadehi, K. El Khamlichi Drissi, and C. Pasquier, “Angular modulation of dual-inverter fed open-end motor for electrical vehicle applications,” IEEE Trans. Power Electron., vol. 31, no. 4,pp. 2980–2990, Apr. 2016.
[11] D. Sun et al., “Modeling, impedance design, and efficiency analysis of quasi-Z source module in cascaded multilevel photovoltaic power system,” IEEE Trans. Ind. Electron., vol. 61, no. 11, pp. 6108–6117, Nov. 2014.
[12] H. Abu-Rub, A. Iqbal, S. M. Ahmed, F. Z. Peng, Y. Li, and G. Baoming, “Quasi-Z-source inverter-based photovoltaic generation system with maximum power tracking control using ANFIS,” IEEE Trans. Power Electron., vol. 4, no. 1, pp. 11–20, Jan. 2013.
[13] O. Ellabban, H. Abu-Rub, and S. Bayhan, “Z-source matrix converter:An overview,” IEEE Trans. Power Electron., vol. 31, no. 11,pp. 7436–7450, Nov. 2016.
[14] F. Z. Peng et al., “Z-source inverter for motor drives,” IEEE Trans.Power Electron., vol. 20, no. 4, pp. 857–863, Jul. 2005.
[15] X. Li, C. Xia, Y. Cao, W. Chen, and T. Shi, “Commutation torque ripple reduction strategy of Z-source inverter fed brushless DC motor,” IEEE Trans. Power Electron., vol. 31, no. 11, pp. 7677–7690,Nov. 2016.
[16] D. Sri Vidhya and T. Venkatesan, “Quasi-Z-source indirect matrix converter fed induction motor drive for flow control of dye in paper mill,”IEEE Trans. Power Electron., vol. 33, no. 2, pp. 1476–1486, Feb. 2018.
[17] F. Z. Peng, “Z-source inverter,” IEEE Trans. Ind. Appl., vol. 39, no. 2,pp. 504–510, Mar./Apr. 2003.
[18] A. Ravindranath, S. K. Mishra, and A. Joshi, “Analysis and PWM control of switched boost inverter,” IEEE Trans. Ind. Electron., vol. 60,no. 12, pp. 5593–5602, Dec. 2013.
[19] J. Anderson and F. Z. Peng, “Four quasi-Z-source inverters,” in Proc.PESC, Rhodes, Greece, Jun. 2008, pp. 2743–2749.
[20] S. S. Nag and S. Mishra, “Current-fed switched inverter,” IEEE Trans.Ind. Electron., vol. 61, no. 9, pp. 4680–4690, Sep. 2014.
Published
2019-12-01
How to Cite
Ramana, V., & Pandian, A. (2019). Operation and Analysis of Modified Quasi ZSI in DCM and CCM. Majlesi Journal of Mechatronic Systems, 8(4), 41-45. Retrieved from https://ms.majlesi.info/index.php/ms/article/view/423
Section
Articles
